Troubleshooting Guide; Warranty - Altrad Belle MEGAVIB+ Manual Del Operador

GB
Problems
Motor doesn't work
Motor works but is overheating
Motor works slowly
Motor make more noise than
normal
The motor works but overloads
and overheats
Bearing failure
GB
Your new Altrad Belle 'Megavib+' is warranted to the original purchaser for a period of one-year (12 months) from the original date of
purchase. The Altrad Belle warranty is against defects in design, materials and workmanship.
The following are not covered under the Altrad Belle warranty:
1. Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow assembly,
operation or user maintenance instructions.
2. Alterations, additions or repairs carried out by persons other than Altrad Belle or their recognised agents.
3. Transportation or shipment costs to and from Altrad Belle or their recognised agents, for repair or assessment against a
warranty claim, on any machine.
4. Materials and/or labour costs to renew, repair or replace components due to fair wear and tear.
The following components are not covered by warranty.
Drivebelt/s
Engine air lter
Altrad Belle and/or their recognised agents, directors, employees or insurers will not be held liable for consequential or other
damages, losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
All warranty claims should rstly be directed to Altrad Belle, either by telephone, by Fax, by Email, or in writing.
For warranty claims:
Tel: +44 (0)1298 84606
Write to:
Altrad Belle Warranty Department,
Sheen, Nr. Buxton
Derbyshire
SK17 0EU

Troubleshooting Guide

Cause / Remedy
Make sure the power is on
Carbon brushes defective
Faulty switch
Cleans the front air vents
Clean or substitute the back lter
Tighten outer casing fasteners
Verify voltage of electrical system
Check the cable speci cation
Verify the cable or length of connection
Defective poker or shaft
Carbon brushes defective
Faulty bearings
The rotor may be toughing the stator
Outer casing broken or fasteners loose
Head is over lubricated
Too much grease in shaft or too little
Failure of seal. The transmission grease has penetrated the head or the head oil has escaped.
Head movement is restricted
Transmission with extreme bends
Transmission in bad condition, broken hose
Not enough oil in head
The head has been working outside concrete for a long time
Water has penetrated the head
The housing has received strong stroke

Warranty

Fax: +44 (0)1298 84722 Warranty@belle-group.co.uk
12