LIGHTSIDE LED BALL Manual De Usuario página 3

LED
BALL
ENGLISH
- Indicator light changes back to green when the battery is fully charged
After charging, disconnect the external adapter from electrical outlet and remove the
light from the station
NOTE:
- Keeping the light power on when charging will extend the charging time. Make sure to
power o the light before charging.
Power the light ON/OFF
To power on the light,you can either press and hold the button on the bottom of Led
ball or press the ON button on the remote control.
Once the power is on, the light will be in red colour.
To power o the light, you can eitreh press and hold the button on the bottom of Led
ball for 2 seconds, or press the OFF button on the remote control.
MODE SELECTION BY REMOTE CONTROL
NOTE: First remove the small plastic sheet from the battery cover before
below operation
To power the unit on, press the red ON button. To power o , press the black OFF button
Adjust the light intensity(3)
Change brightness intensity when the light is xed on one single color
Adjust the speed(3)
Adjust the speed in ash, Fade, Strobe or Smooth mode
Quick selection of 16 static colours (4)
Flash mode (5): 7 colours ash continuously
Strobe mode (6): RGB ashes
Fade mode (7): Scrolling through RGB colours
Smooth mode (8): Scrolling through all 16 colours
Battery replacement (for remote control)
If remote control fails to activate the light,replace the battery
- Press the tab on side of battery cover and then slide o the cover
- Take out the battery and replace a new one. Pay attention to the polarity of battery on
the cover and cover direction when installing them back to the remote control
Warning!
- Make sure that battery is inserted the right way around and with the correct polarity
- Remove exhausted battery from the product
2