Change The Nozzle; Nozzle Type - GreenWorks GPW1800 Manual Del Operador

EN
• The water supply must come from the water main
• Do not use hot water
• Do not use water from ponds or lakes
Do the local regulations when you connect the garden hose
to the water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
Inspect the filter in the water inlet connector before you
connect the garden hose
• If the filter is damaged, do not use the machine until the
filter is replaced.
• If the filter is dirty, clean the filter.
1. Uncoil the garden hose.
2. Let the water flow through the garden hose for 30
seconds.
3. Turn the water supply off.
4. Install and tighten the end of the garden hose to the water
inlet connector.
There must be a minimum of 3 m of free hose between the
water inlet and the water supply.
4.2 USE THE GUN
WARNING
WARNING
CAUTION
CAUTION
English
For safe control, keep your hands on the gun at all times.
• Pull and hold the gun trigger to start the machine.
• Release the gun trigger to stop water flow through the
nozzle.
4.3

CHANGE THE NOZZLE

Before you change the nozzle:
1. Pull the gun trigger to release water pressure.
2. Lock the trigger safety button on the gun.
3. Stop the mahcine.
Do not point the spray wand at your face or others'.
4.3.1

NOZZLE TYPE

SPRAY TIP
O
0
O
25
8
WARNING
1
3
WARNING
WARNING
APPLICATION
Red - Stream tip (0° )
• The red 0 degree tip provides a
straight line of spray. It provides the
highest amount of pressure. It is best
used for removing hard, stuck-on
grime or dirt.
Green - Narrow fan tip (25° )
• The green pressure washer tip pro-
vides high versatility with its 25 de-
gree angle tip. Referred to as the
washing tip, because it provides ade-
quate pressure to remove dirt from
surfaces, but is designed to not dam-
age many surfaces. This pressure
washer tip is designed for "sweep-
ing" foliage or debris given its wide
angle. This tip is versatile due to its
wide area of cleaning and strong
pressure application.
2