Inserting the Fronius SolarCity Card into the inverter
Safety
Requirements for
Only one Fronius SolarCity card per inverter!
installing the Fro-
nius SolarCity
card into the in-
verter
Installing a Fro-
If the Fronius Solar City Card is not installed as standard in the inverter, install the Fronius
nius SolarCity
Solar City Card according the following steps into the inverter.
card into the in-
verter
1
1
12
WARNING! An electric shock can be fatal. Danger from grid voltage and DC volt-
age from solar modules.
-
The inverter should only be opened by licensed electricians, Fronius service
technicians or Fronius service partners.
-
Never work with live wires! Prior to all connection work, make sure that the
AC and DC wires are not charged.
-
All electrical installations must be carried out in accordance with the National
Electrical Code, ANSI/NFPA 70, and any other codes and regulations appli-
cable to the installation site.
-
For installations in Canada, the installations must be done in accordance with
applicable Canadian standards.
WARNING! An electric shock can be fatal. Danger from residual voltage from ca-
pacitors.
You must wait until the capacitors have discharged. Discharge takes 3 minutes.
NOTE! Follow general ESD precautions when handling option cards.
NOTE! A Fronius Solar City card cannot be combined with the following compo-
nents because the Fronius SolarCity card operates in a similar fashion to a data-
logger:
-
Fronius Datalogger pro card or box
-
Fronius Datalogger easy card or box
-
Fronius Datalogger & Interface box
-
Fronius Datalogger Web
-
Fronius Personal Display DL
NOTE! When installing the Fronius SolarCity card into the inverter, you should
follow all relevant information in the inverter operating instructions especially the
safety rules.
AC =
1
OFF
ON
OFF
Lock
3
5
2
2
4
4
3