Tools Required For Assembly - Agri-Fab 45-02933 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

assemBlY InsTruCTIons

Tools reQuIreD For assemBlY

(2) 1/2" Wrenches
(1) Screwdriver
(1) Pliers
1. Remove all items from carton and lay out as shown on
pages 2 and 3.
2. Assemble the axle clamps and four 5/16" SEMS nuts
to the factory installed bolts in the frame tubes. Do not
tighten yet. See figure 1.
FACTORY
INSTALLED
BOLT
AXLE
CLAMP
FIGure 1
3. Slide the axle through the two axle clamps. See figure
2.
4. Assemble a 3-1/8" spacer, a 1/4" spacer, a 3/4" washer,
a wheel (valve stem facing out) and another 3/4" washer
onto the axle. Assemble a cotter pin through the end of
the axle. Repeat on other end. See figure 2.
5. Tighten the four nuts which fasten the axle clamps to
the frame tubes. Refer back to figure 1.
1/8" x 1-1/2"
COTTER PIN
FIGure 2
5/16" SEMS NUT
3-1/8" SPACER
1/4" SPACER
3/4" WASHER
enGlIsH
6. Assemble a hitch arm to the inside of a frame tube
underneath the tank. Use two 5/16" x 2" hex bolts and
5/16" nylock nuts as shown in figure 3. Do not tighten
yet. Repeat for other side.
FIGure 3
7. Fasten the ends of the hitch arms together using two
5/16" x 1-1/4" hex bolts and 5/16" nylock nuts. Do not
tighten yet. See figure 4.
8. Assemble the hitch brackets to the hitch arms using
two 5/16" x 2" hex bolts and 5/16" nylock nuts. Position
each bolt behind a cross bolt in the hitch arms. Do not
tighten yet. See figure 4.
5/16" x 1-1/4"
HEX BOLT
5/16" NYLOCK NUT
FIGure 4
9. Tighten all bolts starting with the bolts in figure 3, then
the bolts in figure 4.
4
5/16" NYLOCK NUT
5/16" x 2"
HEX BOLT
HITCH ARM
5/16" x 2"
5/16" NYLOCK NUT
HEX BOLT

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

45-02933-100

Tabla de contenido