What you should do if...
?
Problem
The shade is hard to open.
Slip-marks on the aluminium
rods.
The shade cannot be tilted.
The shade height cannot
be adjusted.
Maintenance and care
• Allow the sunshade to dry out in an open position to prevent development
of mould, odours and discolouration. Store the sunshade in a dry place once
it is completely dry.
• Clean the canopy of the sunshade if required with lukewarm water, mild
detergent and a sponge. If required, the fabric can be re-impregnated with
a fluorine containing spray.
• The optionally available protective cover should only be pulled over the dry
shade when dry.
• The optionally available protective cover is not to be washed in the was-
hing machine nor dry cleaned.
• Do not use bleach or sharp objects to prevent damage to the coating of the
canopy.
• Clean the shade framework regularly to ensure that the moving parts move
smoothly. If required, use a silicon or Teflon dry lubricant. Wipe away any
slip marks on the aluminium rods with a damp cloth.
• If the sunshade is standing in a very exposed place, increased wear must
be expected. In such cases we recommend more intensive maintenance
and care.
• In most situations, defective shades can be repaired by your GLATZ partner.
Use only original replacement parts from GLATZ.
!
Possible solutions
Service the rods occasionally with
silicon spray.
These are normal marks of use which
can be removed with a damp cloth.
Push tilt lock in fully.
Service the angle joints occasionally
with silicon spray.
Loosen the clamping screw so that it
no longer has any clamping effect.
Service the upper and lower pole
occasionally with silicon spray.
38
39
Disassembly
Disassemble the sunshade if it is not going to be used for a longer period.
WARNING! DANGER OF TIPPING. DANGER OF INJURY CAUSED BY SUNSHA-
DE TIPPING OVER.
1 Close the sunshade correctly and tie up.
2 Take the sunshade out of the base/ground socket and lay it down.
3 Store the sunshade in a lying position along with all accessories
in a dry place.
Disposal
This symbol on the product, accessories or the packaging indi-
cates that the product cannot be treated as unsorted domestic
waste but must be disposed of separately. Dispose of the product
in a recycling collection point intended for this purpose. Disposal
of electrical and electronic devices within the EU and in other
European countries is carried out via collection points which have a system for
separate collection of electrical and electronic devices. By correctly disposing
of the product, you are helping to prevent possible dangers for the environ-
ment and for health which can be caused by incorrect disposal of old devices.
Re-use of materials contributes to the maintenance of natural resources. The-
refore, do not dispose of any old electrical and electronic devices with the un-
sorted domestic waste. The packaging is made from environmentally friendly
materials which can be disposed of in your local recycling facility. By correctly
disposing of the packaging and packaging waste, you are helping to prevent
possible dangers for the environment and for health. The product consists of
metal and plastic parts. Disposal at the end of service life must be carried out
under the terms of the regional environment and waste regulations.