Pool Blaster LEAF VACUUM Manual De Uso página 4

English
Battery Box
1. Remove the set of 8 AA batteries
that are attached to the underside of
the unit.
2. Remove the 2 thumb screws that
hold the cover of the battery cham-
ber and carefully remove the battery
holder that is attached to the wire
terminal connector..
Warning:
Do not mix old and new batteries.
Do not mix Alkaline, Carbon-Zinc, or
Ni-Cad batteries.
3. Install batteries into the holder as
shown. Assure the battery holder
and wire terminal are connected.
Orient the battery holder and wire
terminal to the right side of battery
compartment, as shown in Fig. 1.
4. Insert the batteries into the battery
chamber, as shown in Fig. 2 and Fig.
3.
5. The battery pack must sit deep
into the case. Not doing so will lead
to damaging leakage during use.
6. Place the rubber gasket on the
battery chamber, as shown in Fig. 5.
7. Replace the battery chamber lid
and tighten the thumb screws.
Caution:
DO NOT OVER-TIGHTEN THE
THUMB SCREWS.
SETTING UP THE POOL BLASTER LEAF VAC
Note:
While cleaning, leaves may settle around the propeller re-
ducing cleaning effectiveness. Should this occur, just shake
the Leaf Vac back and forth to dislodge the settling leaves
and continue cleaning.
Attaching the Pool Pole
Slide your pool pole on to the adapter until the plastic clip
snaps into place on the pole.
3
Pole Adapter
Secure the 2 yellow pins to
fasten the adapter in place
as shown.
Debris Bag
1. Place the mouth of the
bag over the yellow collar
on the Leaf Vac.
2. Secure the bag in
place by squeezing the
spring-loaded plastic slide.
Pull on the cord until the
bag tighten beneath the
yellow collar.