Safety Recommendations; Product Description - Fracarro KDSR Instrucciones De Uso

The unit must be installed by qualified personnel according to the local safety regulations in force.
Where to install the unit. Install the unit in a dry place and in an area protected from atmospheric
agents. Leave some space around the unit to ensure ventilation. Do not install the unit above or close
to heating sources, in a dusty area or where it might enter into contact with corrosive substances.
Excessive temperatures and/or excessive heat can lower the performance and the life of the unit.
Humidity, such as condensation, might damage the unit. In the event of condensation, allow the unit
to dry before using it. If the unit has been stored for a long time in a cold place, take it to the place of
installation and wait two hours before connecting it to the feeder.
Grounding the antenna installation: the DIN bar, where the unit will be installed, must be collected
to the ground electrode of the antenna installation according to the EN50083-1 norm, paragraph 10.
We recommend following the provisions of the EN 50083-1 norm and not to connect the DIN bar to the
protection grounding of the power network.
IMPORTANT: only authorized personnel can open the unit. Do not try to repair the unit; otherwise, the
guarantee will no longer be valid. Cut power off before servicing the unit.
The KDSR is a digital receiver for the distribution of satellite digital programs transmitted free-to-air
with QPSK modulation. It receives an QPSK digital transponder from which it extracts audio and video
signals transmitted from a transmitted free-to-air program. These signals generate a channel that will
later be distributed, using a standard TV distribution network. The version of the unit with A/V outlets
can be connected to external modulators.
The modules are installed on a standard DIN bar and are supplied by the KP feeders of the K series.
They are programmed by a TPE programmer. See fig. 1 to spot the SAT signal input (from the dish),
the demixed output of the SAT signal to other modules, the RCA outputs with the A/V signals, the input
of the self-mixing line and the output of the generated signal. The KDSR-AV version doesn't have a
RF output - only RCA outputs.
AUDIO R OUTPUT
AUDIO L OUTPUT
VIDEO OUTPUT
12V
LED
RJ45 OUTLET
FOR TPE
MIX INPUT
(only for KDSR, KDSR-S and KDSR-M)
OUTPUT
(only for KDSR, KDSR-S and KDSR-M)
Fig. 1
See the last pages of these instructions for the complete list of characteristics.
The maximum number of connecting modules in input demixing depends on the level, the quality and
frequency of the SAT signal that you want to receive. Typically, for a good quality signal, the signal
should demix among 5 or 6 modules. KRF15 flexible bridges can be used as well as KRP52 rigid
bridges. To make the rigid bridges installation easier, to ensure the proper ventilation of the modules
and to simplify the installation operations, we recommend using the supplied black plastic spacers.

SAFETY RECOMMENDATIONS

PRODUCT DESCRIPTION

SAT OUTPUT
SAT INPUT
POSITION OF
SPACERS
CLIP HOOK TO THE
DIN BAR

ASSEMBLING ON DIN BAR
KDSR
KDSR-S
3
KDSR-AV
KDSR-M
2
Fig. 2
1
KD100