Notice X7 ANG 2010.qxd
12/07/10
Figure 25
Diaphragm
Figure 26
Figure 28
Figure 29
10:32
Page 12
2 3
•
Then simply remove the Diaphragm from the holder by pulling
it upward
(Figure
•
2
nd
step: fitting the new Diaphragm
Figure 27
Ring
•
Place the upper part of the case in the lower part and screw the
2 parts together.
•
Reinsert the case in the device, after having put the tightening
ring back in place
•
Reposition the housing around the case
•
Place the handle upright and push the clips back into place.
25).
•
Place the new Diaphragm
on the handle and replace the
handle in the casing by aligning
the notches correctly with
the grooves
•
Pull on the handle so as
to ensure that the edge of
the Diaphragm is visible
(Figure
(Figure
28).
(Figure
26).
27).
(Figure
29).