Attaching The Blades - Faro OVNI Manual De Uso

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA
SICHERHEITSHINWEISE / VEILIGHEIDSINSTURCTIES INSTRUZIONI DI SICUREZZA

ATTACHING THE BLADES

1. Insert blades thought slots in side of fan motor and align blade holes with holes in motor. (If holes
do not align, then blade is upside down).
2. Start blade screws with fiber washer into each hole. DO NOT TIGHTEN UNTIL BOTH SCREWS
ARE STARTED. Repeat for remaining blades.
3. Tighten all 10 blades screws evenly and securely to ensure quiet, wobble-free operation of your
fan.
ATTACHING THE GLASS
Put the bulb HALOGEN J78 100W 220V (do not touch the bulb with bare hands)
ELECTRICAL CONNECTIONS
GENERAL INFORMATION
Instaling fan using the remote control:
The remote control's receiver, when installed inside the fan's canopy, will restrict the full tilting movement of
the mounting ball therefore limiting the maximum ceiling slope allowable lo 15 degrees. This is equivalent to
a "3/12 ceiling pitch. If greater pitch is needed it is recommended that wall control installation method
shown on previous page be used.
INFORMATlON AND OPERATING INSTRUCTlONS
1. Setting the code:
This unit has 16 different code combinations. To set the code perform these steps:
A. Setting th e code on the TRANSMITTER:
a. Remove battery cover. Press firmly below TRANSMITTER RECEIVER arrow and slide battery
cover off.
b. Slide code switches to your choice of ON or OFF position. Use a small screwdriver or ball point
pen to slide each switch firmly up or down. (Fig. 1)
B. Setting the code on the RECEIVER:
a. Slide code switches to the same position as set on your transmitter. (Fig 2)
b. Replace battery cover on transmitter.
Transmitter
Halojen bulb
Receiver
Code switches
Code switches
- 29 -
Faro