Preparation And Setup; Working With The Battery-Powered Clipping Machine Favorita Cl /Libra And Charger Gt203/Li-Ion Battery Gt201; System Set-Up; Connecting The Accessories - Aesculap B. Braun Favorita CL Instrucciones De Manejo

3.

Preparation and setup

Non-compliance with these rules will result in
complete exclusion of liability on the part of Aesculap.
When setting up and operating the product, always
observe:
– national regulations
operation,
– national regulations on fire and explosion
protection.
– operating advisories according to IEC-/VDE
regulations.
Fire and explosion hazard!
Do not operate the product in
explosion-hazard areas.
DANGER
Malfunction of, or damage to the
product caused by improper setup!
Do not expose the product to
direct sunlight or moisture.
CAUTION
Do not cover the ventilation
slots of the product.
Connect the product to the
specified voltage of 100 V to
240 V/50 Hz to 60 Hz.
Ensure that the mains power
socket used for supplying the
product is freely accessible.
for installation and
4. Working with the battery-
powered clipping machine
Favorita /Libra and charger
CL
GT203/Li-ion battery GT201

4.1 System set-up

4.1.1 Connecting the accessories

Combinations of accessories that are not mentioned in
the present instructions for use may only be employed
if they are specifically intended for the respective
application, and if they do not compromise the
performance and safety characteristics of the
products.
Please contact your B. Braun/Aesculap Partner or
Aesculap Technical Service (address: see Chapter
Technical Service) with any inquiries in this
respect.

4.1.2 Attaching the Blade

Risk of injury caused by sharp cut-
ting plates!
Apply proper care when handling
WARNING and operating the blade of bat-
tery-powered clipping machine
Favorita
Note
The battery-powered clipping machine Favorita
ships without any blade. Instead, there is a range of
blades available for various applications!
Slide On/Off switch 12 upward to switch on
battery-powered clipping machine Favorita
Libra 3.
Push lever 2 towards the shell of the product.
Mount the blade on blade adapter 1.
Release lever 2.
This completes the mounting of the blade.
/Libra.
CL
/Libra
CL
/
CL
5