General Operation - AEG SRC 4331 Instrucciones De Servicio

WARNING:
Never expose batteries to high temperatures
or direct sunlight or throw batteries into fire for
danger of explosion!
Headphone jack (1)
For headphone operation, use a headphone with
a 3.5mm stereo jack plug, connecting it to the
PHONE jack. The speakers will be muted.

General Operation

Switch device on/off (16)
By pressing the POWER ON/OFF button, you can
put the device into standby mode. Pressing the
button again will switch the device on.
Display brightness
By pressing the SNOOZE/LIGHT button (10), you
can set the brightness of your display.
Volume
By turning the volume control wheel (2) you can
adjust the desired volume.
Setting the time (17)
After connecting the power, display will show
0:00. Press and hold the PROG. / CLOCK
SET button,"0:00" will blink. Press the PROG. /
CLOCK SET button again, then repeatedly press
the DIR- or DIR+ button to set the current
hour time. Press the PROG. / CLOCK SET button
once more, then repeatedly press the
DIR+ button to set the current minute time.
12/24 Hour Toggling
In POWER OFF state, press and hold PROG./
CLOCK SET button (17) until you see clock time
flashes on the display. Press
(7) button to select 12 (12:00) or 24 (0:00) hour.
NOTE:
In the 12hour display, PM = afternoon.
CD Operation
1. Pull the disc door (11) open and place a disc
with the printed side up.
2. Press the POWER ON/OFF button (16) to
turn the unit on.
3. Press the FUNCTION (13) button to select
the CD mode.
4. The total number of tracks will appear in the
display, then playback will begin automatically
and the number of the track being played is
displayed.
5. Tune VOLUME control (2) to adjust the
6. If no disc, then NO is shown in the display.
Repeat
1. Press the MODE/ALARM button (14) while
2. Press the MODE/ALARM button (14) again,
3. If you want to cancel the repeat mode, press
DIR- or
Display
1. During the CD is playing.
2. Press the DISPLAY button (3). The DISPLAY
DIR- (6) or DIR+
Programmed play
1. In stop state, press the PROG./CLOCK SET
2. You can see the memory preset number P01
3. Use the
4. Select the next track with the
ENGLISH
sound.
/ BAND (5) - Stops playback.
►/II (4) - You can pause and continue music
playback. Press again to continue playback.
DIR- (6)
Press 1 x = Restart of the song from the
beginning.
Press 2 x = Skip to the previous song.
Press 3 x = Skip to the song before the previ-
ous song, etc. Press and hold during play-
back to search in reverse through the song.
DIR+ (7) - Press to skip to the next song
and the following songs. Press and hold dur-
ing playback to search forward through the
song.
CD is playing. Repeat indicator will flash, the
selected song will be playing repeatedly.
repeat indicator will stand still, all the songs
on the disc will be playing repeatedly.
the MODE/ALARM button until the repeat
indicator disappears.
will show the CD track number. It will turn
back to the current time display after a few
seconds.
button (17).
and PROGRAM flashes on the display.
DIR- (6) or DIR+ (7) button to
select the desired track and then press the
PROG./CLOCK SET button (17) again.
DIR+ (7) button and press the PROG./
CLOCK SET button (17) again. Repeat the
procedure until all the desired tracks are se-
lected. Press the ►/II button (4), the playback
starts. Press this button to pause briefly the
playback.
41
DIR- (6) or