Melchioni MINERVA 2 Manual De Usuario página 9

exceed 1.2m.
• Make sure hose is not kinked. Make sure that when connected hose does not touch
any warm surfaces.
• It's necessary to change the flexible tube when the national conditions require it.
• Only regulator complies with EN 16129 can be used;. Always use a low-pressure
regulator to connect the gas cylinder to the stove. This regulator for I3+(28-30/37)
must to have exclusively a fixed calibration normalized at 37 mbar for Propane and
30 mbar for Butane. For I3B/P(30), the regulator should have a fixed calibration
normalized at 30mbar.
• To store the product always in dry and slightly moist places , away from the atmo-
spheric agents or factors that could damage the stove itself.
• Reparaiton must be performed only by qualified personnel in the service centers
authorized by the manufacturer or impoter.
• Avoid to block the venturis of burners. Check whether the venturis of burners are
blocked before using the appliances.
• The diameters of cooking vessels which can be used are 120mm~200mm.
• Parts sealed by the manufacturer or his agent must not be altered by the users.
• Any modification of the appliance may be dangerous.
INSTALLATION
• Place the stove on a horizontal surface respecting the instructions indicated in the
chapter of Safety Instruction .
• Check that the gas pipe that you want to use is in accordance with the rules in force
in your country and it has already assembled with the pressure reducer with the cha-
racteristics described in the chapter of Safety Instruction and in the technical data
table.
• Insert into the gas pipe a full mesh metal clamp suitable for LPG gas pipes .
• To insert the gas pipe in the stove gas's connector on the back of the stove and push
it until the pipe is inserted up to the connector for at least 2cm .
• Tighten the metal clamp in order to seal safely the rubber hose to the stove connec-
tor.
LPG cylinder assembly
• Before assembling the cylinder, turn the burner valve's knobs clockwise until them
reach the closed position.
• Place the gas cylinder in a stable and dry surface
• Connect the pressure regulator already assembled to the gas pipe to the LPG cylinder
making sure you have correctly inserted the seal gasket supplied with the cylinder.
• Always use the new gaskets supplied together with the LPG cyclinder.