Ciatronic BS 1238 Instrucciones De Servicio página 41

5....-05-BS 1238 Neu
Cable winding device:
Pull out the cable (1) up to the maximum length indicated with the yellow mark.
Never pull the cable out up to the red mark as the cable winding can be damaged.
Said damages are not covered by the warranty.
Winding
Press the cable (4) winding button and guide the cable. Hold the cable to avoid wrap-
ping.
Nozzle Attachment:
Crevice nozzle/
Brush nozzle:
Floor nozzle:
Releasing the nozzles:
Air Slide:
Open the air slide on the hose handle in order to regulate the airflow or to clear any
particles sticking to the nozzle.
Dust bag replacement display (6):
Hold the hose up into air. If the dust bag change display lights up, the bag is full.
Please change it.
Changing the dust bag:
• Pull the plug out of the socket.
• Open the lid of the dust bag compartment by the handle (7) (until its locks in
place).
• Remove the bag by pulling the fixing device carefully towards the rear in order
to make the bag more easily accessible. Then remove the dust bag by pulling it
upwards.
• Insert a new bag. Please ensure that the bag is located correctly in the guide
mechanism. Close the cover so that it snaps into place.
14.09.2004 8:33 Uhr
For vacuuming upholstery, curtains and in corners and
crevices etc.
"2-in-1" nozzle: When this is folded together it can be
used as a groove nozzle. If you would like to use the
brush nozzle, pull the brush section in the direction of
the arrow until it locks in place.
To clean carpets or smooth surfaces.
Smooth floors: Press down the lever with the brush
symbol with your foot. The brush is
now visible.
Carpets: Press down the opposite lever.
Pull these off while turning slightly.
Seite 41
GB
41