How To Operate; Cleaning And Maintenance; Wall Mount - Comfort Zone CZHV201BS-EU Manual Para El Usuario

Please keep the electrical cord away from the
mobile parts of your fan, as well as away from sharp
objects.
Do not use your fan if you have dropped it and
shows clear visible signs of any damage.
Do not set your fan on wet or humid surfaces, and
avoid cleaning the floor around your unit if this is
under operation.
This fan in not a toy, always make sure children do
not play with it.
Parts identification
1. Bottom
2. Fan blades (mobile parts)
3. Safety grid
4. Adjusting position knobs
5. Operation/Speed control panel
6. Cord winder
2.
4.

Wall mount:

By using a 1/4" drill (not included) make two holes
horizontally aligned with 17,7 inches of separation
(it is not recommended to install the wall support
attachment on prefabricated walls or not stable
walls).
www.comfortzoneproducts.com
.3
3
4.
.5
.1.
.6
.5
Fig. S1
Insert in every hole a 1/4" plastic dowel (included),
then insert in each plastic dowel a 1/64" x 1" screw
(included) no more than 0,8 in deep (Fig. S1)
Insert the screw into base hole and fix well, hang
fan on the wall and make sure it is properly set.

HOW TO OPERATE

Set your "air circulator" on a stable surface, do
not set on a rug or on a carpet or over furniture
or on an uneven floor or over any fabric surface.
Plug the unit to the power supply socket, and
please verify it is turned off and on the "0"
position on the speed control panel before.
In order to put the fan on movement, turn the
switch clockwise to set on the preferred speed:
3=high, 2=medium, 1=low.
Do not set your "air circulator" closer than 3,94
in. of any surface, such as the wall, curtains or
any furniture which could block the air flow.
IMPORTANT: before moving this unit, make sure
that it is set on the "0" position on the speed
control panel (off).

CLEANING AND MAINTENANCE

Fig. A1
Turn the "air circulator" off, on "0" position on
the speed panel.
Unplug your "air circulator" from the power
supply.
Make sure to use a soft, lightly dipped on soap,
cloth. Do not immerse the fan on water or any
other fluid, do not let any water on the inside
of the unit neither. Do not use gasoline, thinner
or any other flammable o corrosive substances,
since these could not only damage the fan, but
the fumes could be toxic, as well.
We recommend to follow these steps for cleaning
the fan blades:
1. Use a screwdriver to unscrew the screws
on the sides of the front grills. (Fig. A.1 and
Fig. A.2)
2. Use a screwdriver to remove the front
grid.
3. Clean the fan blades with a soft, lightly
dipped soaped cloth.
Fig. A2
3
CZHV201BS-EU