Technical Specifications; Storage And Downtime Maintenance - Goalzero YETI 3000 LITHIUM Manual De Instrucciones

Goal Zero Yeti Lithium Roll Cart
The Yeti Roll Cart comes pre-installed on the Goal Zero Yeti 3000 and can be easily
removed when needed.
1. Lay the entire unit on its backside with the outputs of the Yeti facing up.
2. Remove the 4 screws holding the Yeti to the roll cart.
3. Carefully lift the Yeti off the cart.
The included handle is telescoping and can slide up and down while pressing down on the
button.

Storage and Downtime Maintenance

Having your Goal Zero Yeti connected to a power source, like a solar panel or wall plug,
between adventures or while in storage keeps its battery healthy and topped off. This
prolongs battery life and will ensure your Goal Zero Yeti is charged and ready to go all
day, every day.
If you can't keep your Goal Zero Yeti plugged into a power source during storage,
fully-charge your Goal Zero Yeti every 3 months and store it in a cool, dry place.
Failure to maintain your Goal Zero Yeti by following these steps can result in battery
damage which will void the product warranty.
8

Technical Specifications

Charge times
Maximum input (standard)
Maximum input (standard and MPPT)
Wall charger (2x 5A)
GOAL ZERO Boulder 50
GOAL ZERO Boulder 100 Briefcase
Goal Zero Boulder 100
Goal Zero Boulder 200 Briefcase
Battery:
Cell Chemistry
Pack Capacity
Single Cell Equivalent Capacity
Lifecycles
Shelf-life
Management System
Ports:
USB Port (output)
6mm Port (output, 6mm)
12V Car Port (output)
12V Power Pole port (output)
120V AC Inverter (output, pure sine wave)
230V AC Inverter (output, pure sine wave)
UNIVERSAL OR AUSTRALIA (TYPE 1) AC PLUGS
Charging Port (input, 8mm)
Power Pole Charging Port (input)
Expansion Module port
General:
Weight (Yeti & MPPT charger)
Weight (cart only)
Dimensions
Operating Usage Temp.
Certs
Warranty
9 hrs
6 hrs
25 hrs
120-240 hrs
60-120 hrs
60-120 hrs
30-60 hrs
Li-ion NMC
3075Wh (10.95V, 280.8Ah)
842Ah @ 3.65V
500 Cycles to 80% capacity
Charge every 3-6 months
PWM charge controller, low battery protection
5V, up to 2.4A (12W max), regulated
12V, up to 10A (120W max)
12V, up to 10A (120W max)
12V, up to 10A (120W max)
120VAC 60Hz, 12.5A (1500W, 3000W surge)
230VAC 50Hz, 6.5A (1500W, 3000W surge)
14-22V, up to 10A (120W max)
14-22V, up to 30A (360W max)
Covered port under the lid. To be used with Goal Zero
expansion modules only.
68.6 lbs (31.1 kg)
8.9 lbs (4 kg)
10.1 x 15.3 x 13.1 in (25.7 x 38.9 x 33.3 cm)
32-104 F (0-40 C)
12 months
9