Bosch GWS Professional Serie Instrucciones De Servicio página 23

Operating instructions
h) Use ear protectors. Exposure to noise can
cause hearing loss.
i) Use auxiliary handles supplied with the
tool. Loss of control can cause personal injury.
4. Power tool use and care
a) Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job better
and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch
does not turn it on and off. Any power tool
that cannot be controlled with the switch is
dangerous and must be repaired.
c) Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any
adjustments, changing accessories, or
storing power tools. Such preventive
safety measures reduce the risk of starting
the power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
h) Keep handles dry, clean and free from oil
and grease. Slippery handles do not allow
for safe handling and control of the tools in
unexpected situations.
Robert Bosch Ltda.
3_GWS_22U_GWS12U_Page3to30.indd 23
5. Service
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
b) In case of consuming of the carbon
brushes to send the tool by assistance
authorized technique for substitution.
Carbon brushes are of specify them cause
damages to the motor of the tool.
c) if the power cord is damaged, the power
cord shall be replaced by manufacturer,
service or qualified person to avoid the
risk of electrical shock.
Safety warnings that are common for
sanding or wire brushing:
a) This power tool is intended to function as a
wire brush or sand. Read all safety
warnings, instructions, illustrations and
specifications provided with this power
tool. Failure to follow all instructions listed
below may result in electric shock, fire and/or
serious injury.
b) This power tool is not recommended for
polishing, cut-off or grinding. Operations
for which the power tool was not designed
may create a hazard and cause personal
injury.
c) Do not use accessories which are not
specifically designed and recommended
by the tool manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
d) The rated speed of the accessory must be at
least equal to the maximum speed marked
on the power tool. Accessories running faster
than their rated speed can fly apart.
e) The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately guarded or controlled.
f) The arbor size of wheels, flanges, backing
pads or any other accessory must properly
fit the spindle of the power tool.
Accessories with arbor holes that do not
match the mounting hardware of the power
tool will run out of balance, vibrate excessively
and may cause loss of control.
en | 23
F 000 622 320 | 07.2010
28/07/10 11:03