Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Loosen the thumb screw and remove the shoe. Attach
the vacuum cover, and fasten it securely with the thumb
screw.
1
2
► 1. Thumb screw 2. Vacuum cover
NOTE: The circular guide (optional accessory) can be
installed on the vacuum cover.
Using multipurpose bit
Optional accessory
When using the multipurpose bit into the material, hold
the tool at approximately a 45 degree angle with the
edge of the shoe base contacting the material.
Bring the tool carefully to a straight position so the shoe
base contacts the material fully.
Circular guide
Optional accessory
Circular cutting diameters: 10 cm (4") - 34 cm (13-3/8")
Installing circular guide
Remove the thumb screw which secures the shoe.
1
2
► 1. Thumb screw 2. Shoe
Align the projections in the circular guide with the grooves in the
shoe, and secure the shoe and circular guide with the thumb screw.
2
► 1. Projections 2. Shoe
To adjust the cutting depth, loosen the thumb screw
and then slide the shoe with the circular guide. After the
adjustment, tighten the thumb screw securely.
2
3
► 1. Thumb screw 2. Circular guide 3. Shoe 4. Loosen 5. Tighten
10 ENGLISH
1
5
4
1
Publicidad
Tabla de contenido
