Hitachi H 45MA Instrucciones De Manejo página 5

English
SPECIFICATIONS
Voltage (by areas)*
Power Input
Full-load Impact Rate
Weight (without cord, side handle)
* Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Case ........................................................................... 1
(2) Bull Point (SDS-max shank) .................................. 1
(3) Side Handle .............................................................. 1
(4) Hexagon Bar Wrench (for 6 mm screw) ........... 1
(5) Hexagon Bar Wrench (for 5 mm screw) ........... 1
(6) Hexagon Bar Wrench (for 4 mm screw) ........... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Crushing
(1) Bull Point
Overall Length: 280, 400 mm
Asphalt Cutting
(1) Cutter
Surface Roughing
(1) Bushing Tool
Tamping
(1) Rammer
Groove digging and edging
(1) Cold chisel
Overall length: 280, 400 mm
4
(2) Shank
(2) Shank
(110V, 230V, 240V)
870W*
3000/min.
5.4 kg
Scooping Work
(1) Scoop
Hammer Grease A
500 g (in a can)
70 g (in a tube)
30 g (in a tube)
Optional accessories are subject to change without
notice.
APPLICATIONS
\
Breaking concrete, chipping off concrete, grooving, bar
cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility
installation, machinery installation, water supply and
drainage work, interior jobs, harbor facilities and other
civil engineering work.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Installing Tools
NOTE:
When using tools such as bull points, cutters, etc.,
make sure to use the genuine parts designated by
our company.
(1) Clean the shank portion of the tool.
(2) As shown in Fig. 1, pull grip (A) in the direction
of A, and insert the tool into a hole of the front
cap in a state where it is further turned in the
direction of B.