English
PRECAUTION
Keep children and infi rm persons away.
When not in use, tools should be stored out of reach
of children and infi rm persons.
HEAT GUN SAFETY WARNINGS
WARNING
1. This tool is not intended for use by
persons
(including
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning
use of the tool by a person responsible
for their safety.
2. Children should be supervised to ensure
that they do not play with the tool.
3. A fi re may arise if the tool is not used
with care, therefore:
Be careful when using the tool in places
where there are combustible materials.
Do not apply to the same place for a long
time.
Do not use in presence of an explosive
atmosphere.
Be aware that heat may be conducted to
combustible materials which are out of
sight.
Place on its stand after use and follow to
cool before storage.
Do not leave the tool unattended when
in use.
4. Do not use the tool or touch the power
plug with wet hands.
Failure to observe this may result in
electric shocks.
5. Always check the work area prior to use,
and do not use the tool if safety cannot
be guaranteed.
Failure to observe this may result in
infl ammable articles concealed in or
behind invisible areas (cases, ceilings,
fl oors, hollow areas) being ignited.
6
6. Do not stand underneath when using the
7. Do not point the hot wind directly at
children)
with
8. There are cases in which highly toxic
9. Apply heat gently while moving the Heat
10. Check the tool for damage, cracks or
11. Cease operations immediately in the
12. Do not get away from the unit while it is
13. If during use, electricity is interrupted,
tool in elevated locations.
Also, do not catch the power cord on
anything, or allow it to be pulled.
Failure to observe this may result in
accidents.
people or animals. Do not look into the
nozzle. Do not use it as a hair dryer
under any circumstances.
Failure to observe this may result in
accidents or injury.
gas will be emitted if used on plastic,
lacquer or similar materials.
Always ensure that the work area is fully
ventilated, and wear a dust-protection
mask.
Gun up, down, left and right.
Aiming it constantly at a single location
may result in the outbreak of smoke or
fi re.
malformation in the event of it being
accidently dropped or subject to impact.
Damage, cracks and malformation may
result in injury.
event of the tool not operating properly
or if abnormal noises or vibrations
are noticed, and contact a HiKOKI
Authorized Service Center to request
inspections and repairs.
Continued use may result in injury.
switched on. Failure to observe this may
result in accidents.
(e.g. the power plug came out, the
breaker fell, a blackout occurred...) and
the heat gun fan has stopped, please put