HIKOKI WF 18DSL Instrucciones De Manejo página 11

REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe
the following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100Wh are considered to be in the freight classification
of Dangerous Goods and will require special application
procedures.
SPECIFICATIONS
POWER TOOL
Model
No-load speed
Screw size
Capacity
Screw length
Bit shank size
Rechargeable battery
Weight * (According to EPTA-Procedure 01/2014)
* Depending on attached battery. The heaviest weight is measured with BSL36B18 (sold separately).
CHARGER
Model
Charging voltage
Weight
STANDARD ACCESSORIES
(1) Screw feed attachment ...............................................1
(Assembled in main body)
(2) No. 2 Plus Bit ...............................................................3
(Assembled in main body : 1)
(3) Sheet ...........................................................................3
(Assembled in main body : 1)
(4) Plastic case .................................................................1
(5) Battery cover ...............................................................2
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES
(sold separately)
○ Battery
(BSL1840)
Optional accessories are subject to change without notice.
UC18YRSL UC18YFSL
14.4 V – 18 V
0.6 kg 0.5 kg
(BSL36..18)
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Power Output
2 to 3 digit number
WF18DSL
4200 min
25 – 41 mm
6.35 mm Hex.
BSL1840: Li-ion 18 V
(4.0 Ah 10 cells)
1.9 – 2.5 kg
APPLICATIONS
○ Screw driving into indoor gypsum board.
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the driver drill, charge the battery as follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's pilot
lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Firmly insert the battery into the charger, as shown in
Fig. 3.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
English
-1
4 mm
11