Introduction; Setup; Battery Installation; Battery Saver - GE RM24926 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setup

Battery Installation

1. On the back of the remote, push down on the tab
and lift the cover off.
2. Match the batteries to the + and - marks inside the
battery case, then insert 2 AAA Alkaline batteries.
3. Press the battery cover back into place.

Battery Saver

Your remote automatically turns off if the buttons
are depressed more than 30 seconds. This will save
your batteries should your remote get stuck in a place
where the buttons remain depressed (e.g., between
the sofa cushions).

Code Saver

You will have up to 10 minutes to change the
batteries in your remote without losing codes you
have programmed. However, do not press any
buttons until batteries are installed in the remote. If
buttons are pressed without batteries in the remote,
all codes will be lost.

Code Setup

The CODE SEARCH button is used to setup the
remote. You can either setup the remote using the
code tables (on separate sheet), or you can search
through the library of codes until you find a code that
works for your product. Please refer to " Code Search"
on page 10 for more information on using the code
search feature to learn how to search through the
library of codes for your products.
NOTE: You can store any kind of code under any
mode (except TV). I.E. you can store a VCR code under
the CBL button, or a Cable code under the DVD
button, etc. However, you can only store TV codes
under the TV button.
3

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido