Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING: Do not test or adjust the system while the collar is on your dog.
● Adjusting the static correction level
8 static correction levels (modes) are available on each receiver collar so you can adjust the product to your dog (size, sensitivity,
temperament).
In the factory, the collar is set on mode 4.
Always start with a low level of static correction and define the level from which your dog reacts by increasing gradually.
The table below indicates how your collar operates according to the selected mode:
Number of beep sounds heard when
switching modes
1
2
4
5
7
8
To change the static correction level, proceed in the following way:
 When switching on the collar, keep the magnetic key in contact with the
After the beep sound indicating that the collar is on, a series of beep sounds is emitted (from 1 to 8) indicating the selected level.
Levels 1 to 8 run through as long as you leave the magnetic key in contact with the
 Move the magnetic key away from the collar as soon as you have reached the desired level.
The collar will memorize your selected level.
Next time you will switch on the collar, it will be in the level you selected last.
● Safety features
The pet fencing system comes complete with 3 safety features:
 wire break alarm
If the antenna wire breaks or if a connection fails, the transmitter will alert you to this operating default:
 the transmitter will emit continuous beep sounds
 the LCD screen will flash
 a symbol will flash on the screen (ref. Diagram 2)
 warning zone evacuation feature
After approximately 20 seconds of continuous presence in the warning zone, your dog will be signaled to leave the zone by the emission of a
few short static corrections (stimulation level depending on the selected mode).
 static correction zone evacuation feature
If your dog remains in the static correction zone for approximately 20 seconds, the receiver collar stops emitting static corrections. The
normal functioning resumes when your dog leaves this zone.
● Checking and replacing battery of the receiver collar
To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
flashes slowly green: battery sufficiently charged
flashes quickly red: weak battery. Be prepared to replace battery.
Mode
1
2
3
3
4
5
6
6
7
8
Static correction level
low static correction levels:
for small dogs or dogs with sensitive temperament
medium static correction levels:
for medium dogs or dogs with average temperament
strong static correction levels:
for large dogs or dogs with difficult temperament
symbol located on the front of the collar (ref. Diagram 6).
symbol.
- 7 -

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pffugfil095Pffugfil081Cpeleali010

Tabla de contenido