First Start-Up - Wetrok Master Sweep 970 Instrucciones De Manejo

Dear Customers,
Thank you for choosing one of our high-quality Wetrok products.
The MASTER SWEEP 970 system is an especially efficient hand sweeping machine with a permanent brush drive that is simple to operate and can be
used for all even and hard surfaces. The unique Turbo sweeping system with circular brushes and sweeping rolls guarantees double cleanliness. The
circular brushes collect all kinds of dirt from the road, from fine dust to empty cans, wet leaves and even heavy garbage. The sweeping rolls collect fine
dust, and, in addition, ensure the optimal overhead filling of the dirt container. In order to guarantee a long service life of your sweeping machine, the
following operating instructions must be observed.

FIRST START-UP

Assembly of the sliding handle
Push the catch spring of the sliding handle (item.7.12) and connect the sliding handle (item.7.11) with the handle fittings (item 7.13) by engaging the
catch spring. To fit handle to the sweeper frame (Pos 1.12) fold the handle forward to an angle of 45° towards the front brushes, the handle holder will
snap into position. To fix the handle move the handle back to normal sweeping position.
Charging the battery
Charge the battery prior to the first start-up. Please see the chapter "charging the battery".
OPERATION
Height adjustment of the brooms
The MASTER SWEEP 970 sweeping machine is factory adjusted for even surfaces.
The brush pressure can be freely adjusted with the adjusting button (item 1.11).
Step 1-2: new brushes for all even surfaces
Step 3-4: new brushes for wet leaves, sand, uneven floors (e.g. washed-out concrete)
Step 5-8: older brushes for readjustment of the worn brush parts.
Please ensure that the brushes rest only lightly on the floor.
A lower brush position does not bring about better cleaning results and instead may increase the wear on the brushes.
Operation
Turn on the switch (item 10.01) and push the sweeping machine in front of you at normal walking speed (the brushes will point in the opposite direction)
and lift the sliding handle slightly. Bumps with a height of 2-3 cm can be easily driven over by lightly pushing down on the sliding handle. After termi-
nation of the brushing process, turn off the switch (item 10.01) of the machine and recharge the battery
The machine must be turned off as soon as the brushes start to spin slowly –in order to prevent a total discharge and damage of the battery.
The machine can also be operated without its motor. In this case, simply push the machine without turning on the motor.
Overload protection
The motor is provided with an overload protection in order to prevent damage to the machine. In the case of an overload (jammed brooms) the machine
turns off automatically. If this should occur, the first step is to remove the blockage in the brooms (e.g. due to spooled cords etc.). Thereafter, operation
can be continued by restarting the motor.
Deutsch
Français
Italiano
Español
English
Suomi
Nederlands
Svenska
Dansk
Polski
Português
Türkçe
23
DE
FR
IT
ES
EN
FI
NL
SV
DA
PL
PT
TR