Cleaning; After Every Use - Silvercrest SWKS 2200 B1 Instrucciones De Servicio

BB&3( B:DVVHUNRFKHUB%ERRN 6HLWH  'LHQVWDJ  2NWREHU   
or place it on an even surface to be
able to read the water level display|3
correctly.
4. Close the lid|9, by pressing it down-
wards.
5. Place the kettle on the device base|4.
6. Insert the mains plug|6 into a wall sock-
et corresponding to the technical data.
7. Press the on/off switch|5 down, until it
lights up blue and locks into place.
8. The device automatically switches off as
soon as the water starts to boil.
9. Disconnect the mains plug|6 from the
wall socket.
10.Remove the kettle|2 from the device
base|4 and pour the water out.

8. Cleaning

DANGER! Risk of electric
shock!
~ Pull the mains plug|6 out of the wall
socket before you clean the kettle|2.
~ The kettle|2, the device base|4, the
power cable and the mains plug|6 must
not be immersed in water or other liq-
uids.
DANGER! Risk of injury
through scalding!
The kettle|2 becomes very hot during opera-
tion. Allow it to cool down before cleaning.
WARNING! Risk of material damage!
Do not use any astringent or abrasive clean-
ing agents.

After every use

Clean the device after every use, if possible.
1. Disconnect the mains plug|6 from the
wall socket.
2. Wipe the kettle|2, the device base|4
and the power cable|6 with a damp
cloth if necessary. Dry with a dry cloth.
3. Allow all parts to dry completely before
you put them away or use the device
again.
NOTE: the kettle|2 can also be cleaned on
the outside with stainless steel cleaners from
specialist retailers.
Cleaning the limescale filter
1. Open the lid|9.
2. Pull the limescale filter|1 off upwards
from the kettle|2.
3. Clean the limescale filter|1 with a moist
dishcloth under running water.
4. Slot the limescale filter|1 into the intend-
ed fitting in the kettle|2 and press it
downwards.
Descaling
After some time, the boiling process will re-
sult in limescale being deposited in parts of
the kettle (depending on the hardness of the
water used). You should remove this at regu-
lar intervals, because otherwise the power
consumption of the device will increase.
1. Pull the limescale filter|1 off upwards
from the kettle|2. If there is limescale
residue in the limescale filter|1, place it
in the kettle when descaling.
2. Fill the limescale remover into the ket-
tle|2. Use a commercially available li-
mescale remover, e.g. limescale
remover for coffee machines. Comply
with the instructions on the packaging
of the limescale remover. You can find
the next steps in the instructions of the li-
mescale remover. Rinse the kettle multi-
ple times after descaling, if necessary.
3. After descaling, rinse the limescale fil-
ter|1 well. Slot it into the intended fitting
in the kettle|2 and press it downwards.
37
GB