Steinbach Speedshower Magic Manual De Instrucciones página 3

EN
We recommend installation of the Outdoor Solar Shower to a solid
surface to insure stability and safety.
When using tools, care must be taken not to damage chrome
plating.
We recommend using a cloth between wrench and shower parts to
avoid damage.
MOUNTING THE SOLAR SHOWER: CONCRETE/MASONRY
INSTALLATION ONLY
1. Choose a location for shower that receives the most direct
sunlight.
2. Use the base plate/PVC tube to mark the position of the mounting
holes to be drilled into concrete/masonry for bolts.
3. Remove shower section. Drill 10mm (0.47") diameter holes,
50mm (1.77") deep, using the marks just created.
4. Insert expansion nuts into drilled holes. Place the bolt inside the
expansion nut and TAP with a hammer to slightly expand the nut.
5. Remove bolt and place the base plate/lower tube over the holes
and secure to surface with bolts and
NOTE: Base plate will appear loose until shower is fully secured
to the surface.
ASSEMBLING THE SOLAR SHOWER - Figure 1
DUE TO THE SOLAR RADIATION THE WATER IN THE SOLAR
TANK CAN GET HOT.
WE RECOMMEND OPENING THE HANDLE IN THE MIDDLE
POSITION BETWEEN HOT AND COLD, THEN SETTING TO
DESIRED TEMPERATURE.
IF SHOWER HAS NOT BEEN USED FOR MORE THAN THREE
DAYS, WE RECOMMEND
RUNNING SOLAR SHOWER FOR 2 MINUTES TO REMOVE
STAGNANT WATER. STAGNANT WATER IN
A WARM ENVIRONMENT
ENVIRONMENT FOR HAZARDOUS BACTERIA.
Using the shower
The Solar shower is equipped with a mixing valve, where the first
cold water and then hot water is flowing. The valve must not be over
tightened, since this may
Connect the water hose to the shower and let the water warm up by
the sun. (12 to 24 hours, depending on the ambient temperature and
solar radiation) Once the water is hot, open the valve until the
desired temperature
To fill the solar tank, turn the valve to hot and wait until the shower is
completely filled. Once filled, close the valve and let the warm water
warm up for several hours.
When the water drips furthermore with a closed mixer, it is possible
that the water pressure is too high. Reduce this by fitting in a
pressure regulator.
OFF SEASON DISASSEMBLY & STORAGE:
DURING THE WINTER THE WATER HAS TO BE REMOVED
FROM THE SOLAR SHOWER COMPLETELY. FURTHERMORE
Speedshower Solardusche MAGIC | 2015_V1
washers provided.
CAN PROVIDE A GROWTH
be damaged irreparable.
is reached.
THE SOLAR SHOWER HAS TO BE KNOCKED DOWN IN WINTER
AND STORED IN A DRY PLACE. FAILURE TO FOLLOW THESE
INSTRUCTIONS MAY CAUSE FROST DAMAGE ON MATERIAL ->
FROST DAMAGE WILL NOT BE RECOGNIZED AS A CLAIM.
1. Turn off and disconnect garden hose.
2. Open handle and allow shower to drain (approximately 2
minutes).
3. Turn lock nut COUNTER CLOCKWISE to unthread, and pull
stainless steel pipe apart.
4. Unbolt shower PVC tube and pour remaining water out of unit.
5. Wipe down and store shower parts for next season.
DO NOT USE SALT OR ANTI-FREEZE IN WATER TO PREVENT
FREEZING. THIS WILL VOID THE PRODUCT WARRANTY.
Keep this manual. Please include the manual with the product upon
transfer of ownership.
Steinbach VertriebsgmbH,
Aistinger Straße 2, 4311 Schwertberg, Österreich
e-mail: service@steinbach.at
www.steinbach.at
https://service.steinbach.at
Page 3 of 16