Sony WRR-805A Manual De Instrucciones página 12

Settings
7
Once the desired wireless channel is displayed, press the
SET button.
The display stops flashing and the selected group and
wireless channel are now stored in memory.
To select the channel by frequency indication
1
Turn on the unit and press the MODE button until the
frequency indication appears on the display.
2
Press the SET button.
The frequency indication starts flashing.
In frequency selection
mode
Display example for WRR-805A/CE62 model
3
Press the + or – button to select the channel frequency.
4
Once the desired frequency is displayed, press the SET
button.
The display stops flashing and the selected channel
frequency is now stored in memory.
10
(GB)
Notes
•
Do not remove the batteries during group and wireless
channel selection. If they are inadvertently removed, re-
insert them immediately and repeat the above steps from
the beginning.
•
Make sure that the channel selected is the same as that
selected on the transmitter used in the same system.
•
Depending on the noise or interference conditions, the
selectable channels may not necessarily all be usable. If
necessary, you can determine the usable channels by
stepping the channel selection through a number of
channels on the tuner with the microphone/transmitter set
to OFF. Those channels on which the RF indicator of the
tuner does not light are usable.
•
If there is a TV broadcasting station near by, do not use
the station's channel.
•
The unit may not operate correctly if it is turned on again
immediately after turning off the power while in setting
mode. Pause for a few seconds or more before turning on
the power again.
•
When operating two or more UHF wireless microphone
systems using channels in different groups, ensure that the
systems are at least 100m (330 feet) apart from each other.
(The same applies also when using channels in a group if
the different UHF wireless microphone systems are
installed where they are within sight of each other.)