Sears Kenmore Elite 721.8758 Serie Manual De Instalación página 10

STEP 3: Prepare he Venting Blower
WALL-VENT INSTALLATION:
1. Remove one or two blower unit mounting screw(s) and one
or several blower plate mounting screw(s). Remove the
blower plate from
2. Carefully lift the blower unit out of the microwave oven.
See Figure .
3. Use side cutters or tin snips to cut and remove knockouts
B from Back plate. Discard knockouts. Be careful not to
distort the plate. See Figure 1 .
4. Reassemble the blower wire. See Figure 1 .
5.
of the cabinet
. Reattach the blower plate to microwave oven so the exhaust
ports and blower plate opening are aligned. Attach with one
blower unit mounting screw and then one or several blower
plate mounting screw(s). See Figure 1 .
. Insert the tabs on each side of the damper into the holes
at the inside rear of the adapt r.
Attach the exhaust adapt r to the
Push in securely until it is past the
and in the lower locking tabs. Take care to
the damper hinge is installed so that it is at the top
and that the damper swings freely.
Figure 1
Blower Unit
Blower Unit
Exhaust Ports
Figure
cabinet. See Figure 1 .
Blower Plate
Mounting Screw
Blower Plate
Back Plate
Blower Unit
Mounting Screw
Blower Unit
Blower
Unit
Exhaust Ports
Figure 1
Exhaust Adapt r
Slide exhaust
adaptor into
guides on
rear panel.
– 1 –
Blower Plate
Mounting Screw
Blower Unit
Mounting Screw
Parts B
Figure 1
Figure 1
Parts B
Figure 1
Exhaust
Ports
Figure 1
Locking
Tabs
Figure
Blower Plate
Back Plate
Knockouts Parts B
Damper
(hinge side up)
Guides