Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
Electrical connection
(non-Canada) - 3 wire cord
3-wire receptacle
(NEMA type 10-30R)
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source be-
fore servicing could result in personal
injury or even death.
1. Turn off power supply to outlet.
2. Remove the screw securing the
terminal block access cover on the
back of the dryer.
3. Install a UL-approved strain relief
according to the power cord/strain
relief manufacturer's instructions in
the power cord entry hole below the
access panel. At this time, the strain
relief should be loosely in place.
4. Thread an UNPLUGGED, UL-
approved, 30 amp. power cord,
NEMA 10-30 type SRDT, through the
strain relief.
30 AMP
NEMA 10-30
5. Attach the power cord neutral (center
wire) conductor to the SILVER colored
center terminal on the terminal block.
Tighten the screw securely.
6. Attach the remaining two power cord
outer conductors to the outer, BRASS
colored terminals on the terminal
block. Tighten both screws securely.
DO NOT make a sharp bend or crimp
wiring/conductor at connections.
7. Follow manufacturer's guidelines for
8. Reinstall the terminal block cover.
IMPORTANT
If moving dryer from a 4-wire system
and installing it in a 3-wire system,
move the internal ground from the cen-
Neutral
ter terminal back to the GREEN screw
(center wire)
next to the terminal block.
17
DO NOT remove
internal ground in
a 3-wire system!!
WARNING
ELECTRICAL SHOCK HAZARD
firmly securing the strain relief and
power cord.
Neutral
terminal
Publicidad
