GRE SF133 Manual De Instrucciones página 7

7. ADJUSTING THE LENGTH OF A PANEL
Sometimes it is necessary to modify the length of a panel. For this purpose, stick to the following procedure with a
standard panel.
A) Determine the length of the panel that you wish to modify by measuring the distance between the centre of both holes
on the floor.
B) Move that distance on the section of the panel you wish to modify from the centre of the pole that will be in place. Take
into consideration the distance on the superior and inferior parts of the net.
WARNING: The distance between two poles must always be equal or inferior to 100 cm.
C) With the scissors, cut the fabric AIMING TO LEAVE 10 CM OF EXCESS LENGTH IN ORDER TO BE ABLE TO MAKE AN
ADJUSTMENT IN CASE OF ERROR.
D) Release the flange of the unused pole (for example, the one connected to the excess fabric you have just cut). In order
to release the flange, use an electric screwdriver and a standard bit holder (this corresponds to the flange screw).
C
D
B
E) With the help of the cord, trace a straight line between the two marks made in step b).
F) Fold the fabric on itself at 1.5 cm from the line traced previously.
G) Place the fabric on the pole in such a manner that the flange screw holes are aligned with the line traced in step e). The
line should fit perfectly with the flange screws. Place the flange and screw it on again completely. Make sure you place
the pole in the right direction.
E F G
H) Try to replace the panel. If the section has not been modified, go back to stage a).
I) If there is a need to cut excess fabric in the panel, be careful to cut the right segment.
J) OPTIONAL: In order to avoid fraying of superior and inferior edges, a small welding device or lighter may be used to weld wires.
H I J