Preparing The Wireless Remote; Installing The Battery; Changing The Transmitting Frequency - Sony CDX-52RF Manual De Instrucciones

Use the unit with the door closed
Otherwise, foreign matter may enter the unit,
and contaminate the lenses inside the CD
changer.
Notes on the disc magazine
• Do not leave the disc magazine in locations
with high temperatures and high humidity,
such as on a car dashboard or in the rear
window where the disc magazine will be
subjected to direct sunlight.
• Do not insert more than one disc at a time
into a slot, otherwise the changer and the
discs may be damaged.
• Do not drop the disc magazine or subject it to
a violent shock.
Preparing the wireless
remote

Installing the battery

Replace the battery with a Sony CR2025 or
Duracell DL-2025 lithium battery. Use of
another battery may present a risk of fire or
explosion.
When the battery becomes weak, you will not
be able to operate the unit with the wireless
remote.
Battery life is approx. six months although it
depending on the conditions of use.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or dispose of
in fire.
Actual total number:
Notes on the lithium battery
• Keep the lithium battery out of the reach of
• Wipe the battery with a dry cloth to assure a
• Be sure to observe the correct polarity when
• Do not hold the battery with metallic
Mounting the wireless remote
Use the supplied velcro tapes and mount the
wireless remote to a suitable location where it
will not interfere with your driving.
Changing the transmitting
frequency
+ side up
Because this unit processes CD playback
sound through an FM tuner, there may be
interference noise during CD playback. In this
case change the frequency of the modulated
RF signal transmitted from hideaway unit. The
initial setting is 88.3 MHz.
1
2
3
Note
Be sure to set the frequency of your FM tuner to that of the
newly selected frequency.
Sony CDX-52RF (E, S, C) 3-856-013-32 (1)
children.
Should the battery be swallowed,
immediately consult a doctor.
good contact.
installing the battery.
tweezers, otherwise a short-circuit may
occur.
Velcro tapes
Press (REP) for two seconds.
Press either the left or right side of
(AMS) to select the frequency.
Each time you press (AMS), the frequencies
change as follows:
=: 88.3 MHz n 89.9 MHz n 89.7 MHz n
89.5 MHz n 89.3 MHz n 89.1 MHz n
88.9 MHz n 88.7 MHz n 88.5 MHz n
88.3 MHz
+: 88.3 MHz n 88.5 MHz n 88.7 MHz n
88.9 MHz n 89.1 MHz n 89.3 MHz n
89.5 MHz n 89.7 MHz n 89.9 MHz n
88.3 MHz
Press (REP) for two seconds.
to where it is
going to be
mounted
EN
5