Maintenance And Inspection - HIKOKI W 6VM Instrucciones De Manejo

English
SPECIFICATIONS
Model
Voltage*
Power input
No load speed
Capacity
Bit shank size
Weight (without cord)**
* Be sure to check the nameplate on product as it is subject to change by areas.
** Weight: According to EPTA-Procedure 01/2014
NOTE
Due to HiKOKI's continuing program of research and development, the specifi cations herein are subject to change
without prior notice.
MOUNTING AND OPERATION
Action
Confi rm the direction of bit rotation
Adjusting the tightening depth
Tightening depth for hex head screws
Tightening depth for drywall screws
Tightening depth for cross-recessed
self drilling screws
Dismounting the hex-socket
Dismounting the bit
Dismounting the bit
Switch operation
Locking-on the On / Off switch
Releasing the On / Off switch
W6VM W6V4
(110 V, 120 V, 127 V, 220 V, 230 V, 240 V)
0 – 6000 min 0 – 4500 min
–1
1.4 kg
Figure Page
1 112
2 112
3 112
4 112
5 113
6 113
7 113
8 113
9 113
10 113
11 113
W6VA4
620 W
0 – 3000 min
–1 –1
6 mm
6.35 mm Hex.

MAINTENANCE AND INSPECTION

1. Inspecting the hex-socket (or bit)
Since continued use of a worn hex-socket (bit) will
damage screw heads, replace the hexsocket (bit) with a
new one as soon as excessive wear is noticed.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool.
Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4. Inspecting the carbon brushes
For your continued safety and electrical shock protection,
carbon brush inspection and replacement on this tool
should ONLY be performed by a HiKOKI Authorized
Service Center.
5. Service and repairs
All quality power tools will eventually require servicing or
replacement of parts because of wear from normal use.
To assure that only authorized replacement parts will be
used, all service and repairs must be performed by a
HiKOKI Authorized Service Center, ONLY.
CAUTION
○ Be sure to follow the above assembly procedures
exactly. Should be internal wiring contact the armature
or become pinched between the handle cover and
housing, a serious risk of electric shock to the operator
would be created.
○ Do not tamper with parts other than those necessary to
eff ect carbon brush replacement.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
4
W6VB3 W8VB2
0 – 2600 min 0 – 1700 min
–1
8 mm
1.5 kg
–1