Heating capacity
8.
You can select from two heating capacities:
"Low" level for lower capacity
"High" level for more capacity
9.
Note: It takes a few moments until the higher capacity is completely active.
10. Use the
button to select the desired capacity. The respective indicator
lamp shows the level at which the appliance is operating.
11. Oscillation function / swing function
12. With this function it is possible to distribute the air flow over a larger area,
because the appliance swings back and forth in a specific radius.
13. The oscillation function can be switched on in every mode. To do this, select
the
button. If you want to stop the appliance in a specific position,
press the
14. Switch off the oscillation function before you switch off the appliance.
Time setting
15. With this function you select the time period during which the appliance
provides heat. After this time elapses the appliance switches off.
16. When the appliance is switched on, press the
in the display will flash.
17. Use the "+" and "-" buttons to set the desired time between 1 hour and
12 hours. If you select 0, the time setting is not active and the appliance
will run continuously.
18. To save the time setting, press the
Selecting the temperature
19. Now you can select the desired heating temperature. Press the
twice.
20. The pre-set value of 25°C appears in the display. Use the "+" and "-"
buttons to select the desired temperature in a range between 15°C und
35°C.
21. The selected temperature is shown in the display.
22. Confirm the selected temperature by pressing the
23. The appliance shows the current room temperature, the set temperature will
be maintained automatically.
24. When you touch the
5 seconds. If you make no input within these 5 seconds, the display will
show the current room temperature. If the room temperature is below -9°C,
"LO" is shown in the display, if the temperature is above +39°C, the display
shows "HI". At temperatures between -9°C and + 39°C the actual room
temperature is displayed.
Copyright UNOLD AG | www.unold.de
button again.
button, the information in the display will flash for
(approx. 1,200 watt)
(approx. 2,000 watt)
button. The information
button again.
button again.
button
27