Maintenance And Repairs; Warranty Terms - Bossini Z00063000073005 Instrucciones De Montaje

MAINTENANCE AND REPAIRS

Premise: Continuous and extended use over time and the properties of the local water supply may lead to
a loss of efficiency of the cartridge. Therefore, maintenance, cleaning or replacement may be necessary .
1. Close every water inlet connections to the mixer.
2. Remove the cap (9) and unscrew the threaded pin (8); extract the mixing/on-off handle (7); only for version with
square exposed parts unscrew also the knob (12); finally remove the cover plate (6). (fig. 12)
3. Unscrew the cover threaded bush (5) and the threaded ring (4). It is recommended to protect the contact
between the operating wrench and the threaded bush and the threaded ring.
4. Extract the mixing cartridge (3):
In case of maintenance only, remove possible dirty residues or scales deposited inside the cartridge
seat. Immerse the cartridge in a water and vinegar solution (50% + 50%) for about 12 hours, in order to
remove lime scale and impurities, then continue from point no. 5;
In case of replacement of the cartridge, start from point no. 5;
5. Insert the new mixing cartridge (3) paying attention to the 2 pins sticking out from the base; they must be
entered in their specific seats (fig. 13). Screw the threaded ring (4) and clamp by applying a force of 12 Nm.
6. Screw the cover threaded bush (5).
7. Unscrew the diverter cartridge (10) and remove any residue or impurities in its seat; (Fig.13).
8. Screw in the new diverter cartridge (10) and lock into place.
assemble the knob only after positioning of the cover plate).
9. Open the water inlet.
10. Replace the cover (6).
11. Insert the mixing/on-off handle (7) keeping the hole pointed upwards. Fasten the handle by the specific
threaded pin (8) and insert the cap (9). For version with square exposed parts, screw also the knob (12).
12. Clean carefully with a cloth (Fig.
CLEANING
To keep the material's appearance as long as possible, a few guidelines must be followed.
Cleaning metal parts: water contains calcium that deposits on surfaces and forms unpleasant spots. For
routine cleaning,simply use a damp cloth with a little soap, rinse and dry. Calcium spots can therefore be
avoided by drying after use.
Important note: Using only a soap-based detergent is recommended. Never use abrasive detergents or
disinfectants or those containing alcohol, hydrochloric acid or phosphoric acid.
Dear Customer, we would like to remind you that the warranty on our product's surface is not valid if the
material undergoes treatment different than that suggested. The warranty does not cover any damage
due to deposits of calcium or impurities.

WARRANTY TERMS

Dear Customer,
We congratulate you and thank you for choosing a Bossini quality product
The product is guaranteed against any defects due to manufacturing faults as specified hereunder:
1) 5 Years casting defects or porosity
2) 2 Years chromium plated surfaces defects (not including defects / deterioration caused by use of abrasive or
acid detergents)
3) 2 years cartridges / headworks (except for seals and o-ring washers)
4) 2 years thermostatic cartridges / thermostatic elements (which wear and tear time depends on quality of
the water supplied)
5) Repair or replacement of parts evidencing manufacturing defects, acknowledged by our technical
department.
22
).
14
(For version with square exposed parts,