Replace The Cutting Line; Transportation And Storage; Move The Machine - GreenWorks Pro STB405 Manual Del Operador

Make sure that you put the cutting line in the slot on the
new spool and extend the line approximately 15 cm before
you install the new spool.
7. Put the ends of the cutting lines through the holes.
8. Extend the cutting line to release it from the guide slot in
the spool.
9. Push the tabs and install the spool cover onto the spool
housing.
10. Push the spool cover until it clicks into position.
10.4

REPLACE THE CUTTING LINE

NOTE
Remove the remaining cutting line on the spool.
NOTE
English
Use only with the nylon cutting line of 0.080" (2 mm)
diameter.
1. Cut a piece of cutting line approximately 3m long.
2. Bend the line at the midpoint and hook the loop into the
slot in the center rim of the spool. Make sure that the line
snaps into position in the slot.
3. With your finger between the lines, wind the lines equally
and tightly around the spool in the indicated direction.
4. Put the lines in the guide slots.
5. Do not wind the lines beyond the edge of the spool.
11 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before
tranportation and storage.
11.1

MOVE THE MACHINE

When you move the machine, you must:
• Stop the machine.
11
NOTE
Slot
WARNING
EN