Explore Scientific RDP1001 Manual De Instrucciones página 10

OPERATION
1. At the set time, alarm signal rings.
2. During the alarm, press the [
lay the alarm by 8 minutes.
3. If you do not press any button to stop the alarm, it
will automatically turn off after 5 minutes.
4. To stop the alarm, press the [
ton.
5. The alarm will start again at the next alarm time,
unless you switch off the alarm function by press-
ing the [ ] button.
PROJECTION
The projector displays the time on your ceiling or wall
and it can rotate 180°. It is easier to view in a darkened
room. For the optimal projection results, place the unit
within 1.5 - 2 m (5-6.5 ft) from the ceiling or wall.
1. Press [ ] button to activate the backlight
and projection for 5 seconds.
2. Press and hold [
display 180°.
10
] button to de-
] or any other but-
] button, flip the projection
3. Press and hold [
ues projection on in case of using adapter power
source and toggle projection on for 5 minutes in
case of using batteries power only. Press and hold
[ ] button again, turn off projection and tog-
gle continues projection off.
] button, toggle contin-