Important Safety Warning; Tools Required - Tappan TGF605WFW5 Instrucciones De Instalación

IMPORTANT SAFETY WARNING

This range must be properly secured to the floor by using the
included anti-tip brackets and screws. Failure to install the
brackets could allow the range to accidentally tip over if ex-
cessive weight is placed on an open door or if a child climbs
upon it. Serious injury might result from spilled hot liquids or
from the range itself. Refer to the instructions below for
proper installation. Figure A.
NOTE: If the range is ever moved to a different location,
the anti-tip brackets must also be moved and in-
stalled with the range.
ANTI-TIP BRACKET INSTALLATION
INSTRUCTIONS
The anti-tip kit is located in a plastic
bag in the oven.

TOOLS REQUIRED:

5/16" Nutdriver or Flat Head Screwdriver
Adjustable Wrench
3/16" Dia. Masonry Drill Bit (if installing in concrete)
Attach brackets to the floor at the back of the range to hold
both rear leg levelers. When fastening to the floor, be sure
that screws do not penetrate electrical wiring or plumbing.
The screws provided will work in either wood or concrete.
Range may be anchored to floor in a dwelling house with
hold down brackets as illustrated in Figure "A". These hold
down brackets allow range to be freely pulled out from the
wall for cleaning or servicing without the use of tools.
1. Attach brackets to the floor or rear wall with screws
provided. Important: Attachment must be secured to
solid floor or wall. Do not attach to plaster, sheet rock,
or other soft material. If attachment is to rear wall, any
moldings must be removed in area behind range.
2. If brackets are to be attached to masonry or ceramic
floors, position brackets on floor and mark hole
location. Drill 3/16" holes.
3. Lower both rear leg levelers about three turns so the
brackets will slide over leveler head.
4. Level the range front to back and side to side with the
two front leg levelers and the rear levelers.
5. Slide range into place making sure rear legs are trapped
by ends of brackets. Range may need to be shifted
slightly to one side as it is being pushed back to allow
rear legs to align with brackets. Remove lower panel or
storage drawer to inspect brackets or grasp the top rear
edge of the range and carefully attempt to tilt it forward
to make sure range is properly anchored.
For mobile homes, the range must be anchored to the floor
as illustrated in Figure "B".
1. Remove false panel or storage drawer to gain access to
the anchoring holes.
2. A 1/4" diameter hole is provided in the center of each
base rail for anchoring to floor.
Figure A
HOLD DOWN BRACKETS
3 / "
8
2 SCREWS
PER BRACKET
Figure B
BASE RAIL
HOLE FOR ANCHORING
RANGE TO FLOOR
HOLE LOCATED APPROX. MID-WAY
OF BASE RAIL
WARNING:
door or drawer of this range can result in serious injuries
and also cause damage to the range.
8
INSTALL
BACK EDGE OF RANGE
OR REAR WALL
RANGE SIDE PANEL LOCATION
Stepping, leaning or sitting on the
3 / "
8
BODY SIDE
FRONT FRAME