Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting drain and electrical
1 Snap one end of the drain hose hanger (shipped in
washer drum) onto the drain hose. Continue wrapping it
around the hanger and snap it in place.
2 Place the hook end of the drain hose in the drain
opening. Secure the drain hose with the cable tie
(provided in the enclosure package) to the standpipe,
inlet hose, laundry tub, etc. so the hose does not pull out
from the force of the water.
IMPORTANT
Check to ensure the power is off at a circuit breaker/fuse box
before plugging the power cord into an outlet.
3 Plug the power cord into a grounded outlet.
Grounding type
wall receptacle
Do not, under
any circumstances,
cut, remove,
or bypass the
grounding prong.
Power cord with
3-prong grounded plug
4 Turn on the power at a circuit breaker/fuse box.
5 Carefully slide the washer to its final position. Recheck
for level and rock corners for stability. Remove and
discard door tape.
6 Read the Use & Care Guide provided with the washer. It
contains valuable and helpful information that will save
you time and money.
7 If you have any questions during initial operation, please
review the "Service Prevention Checklist" in your Use &
Care Guide before calling for service.
8 Place these instructions in a location near the washer for
future reference.
NOTE
A wiring diagram and technical data sheet are located under
the washer top panel, on top of the detergent dispenser
housing.
Installation Instructions
CABLE TIE
9
Publicidad
