Water Drainage - Zibro D 116 Instrucciones De Uso

The timer function enables you to switch the device off after a certain time. The
5
operating time can be set between 1 and 12 hours with the
you press the button, the running time is extended by 1 hour. This will be shown on
the display. The display will show the relative humidity level after 10 seconds. When
the pre-set time has elapsed, the device will switch off.
Press the
6

WATER DRAINAGE

When the water container is full, the
off automatically. Empty the container and replace it in the correct position. The device
will restart.
If desired, it is possible to connect a drainage hose to the device for permanent water
drainage. Follow these steps:
Unscrew the cap on the back.
1
Remove the rubber stop from the drainage spout.
2
Connect the drainage hose and ensure that the end of the hose is lower than the
3
spout, otherwise the water will not drain and flooding may occur.
Place the end of the drainage hose in a water outlet.
4
When you no longer wish to use the permanent water drainage, disconnect the drainage
hose from the device. Push the rubber stop back into the drainage spout and replace the
cap. Ensure that the water container is positioned correctly.
4
38
-button to turn the device off.
-light switches on and the dehumidifier switches
-button. Every time