Maxx Ice MCWC28 Manual De Servicio página 8

CELLAR TROUBLESHOOTING
Cellar does not turn on
Not plugged in. Fuse blown or circuit breaker tripped.
Noise or vibration
Check that unit is level. If not, adjust leveling legs.
Cellar is too warm
Check that door is properly closed and sealed. Check temperature setting. (To
change the temperature setting, follow the steps in the Operating Your Wine Cellar
section of this manual.) Check if door has been opened frequently.
LCD displays "PROBE ERROR - E"
This message is an ALARM MODE indication. The LCD displays "PROBE ERROR" on the
left and "E" in the middle when the thermostatic sensor has malfunctioned. When this
happens, the cellar first stops working for 15 minutes, then turns ON for 5 minutes and
OFF for 15 minutes automatically and continuously. Contact your authorized service
facility for sensor replacement.
LCD displays "LOW TEMP"
This message is an ALARM MODE indication. The LCD displays "LOW TEMP " on the left
and the actual temperature reading in the middle. It indicates that the actual tem-
perature is much lower than your set temperature and that the magnet valve may
not be functioning properly and should be replaced.
LCD displays "HIGH TEMP"
This message is an ALARM MODE indication. The LCD displays "HIGH TEMP " on the
left and the actual temperature reading in the middle. It indicates that the actual
temperature is much higher than your set temperature. Possible causes are:
N The door might not be fully closed.
N Requires service.
N The control panel may not be functioning properly and should be replaced. If you
are certain that the door is not the cause of the problem, contact your authorized
service facility immediately.