Hitachi Koki CR 18DL Manual De Instrucciones página 15

<UC18YRL, UC18YFL>
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, the charge
status lamp will blink in red. (At 1-second intervals)
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 5. Make sure it contacts the
bottom of the battery charger.
Charge status lamp (red)
Overheat lamp (green)
3. Charging
When the battery is connected to the battery charger, charging will commence and the
pilot lamp will light in red. (See Table 2)
NOTE: If the pilot lamp flikers in red, pull out the plug from the receptacle and check if
the battery is properly mounted.
When the battery is fully charged, the pilot lamp will bilink in red slowly. (At 1-second
intervals) (See Table 2)
WARNING:
Do not use the electrical cord if damaged. Have it repaired
immediately.
Battery
Fig. 5
English
15