Publicidad
Idiomas disponibles
Idiomas disponibles
3. DOWN Button at the rear
In normal display mode press this button to toggle between degrees Celsius or
Fahrenheit.
4. HISTORY Button
Press this button repeatedly to show the history record of the barometer of the past
12 hours. The hour is displayed in the bottom right corner of the barometer chart.
In normal display mode press this button to check the barometer history of 12 the past
hours.
In normal display mode press and hold this button for 3 seconds to enter sea level
setting.
5. MAX/MIN Button
Press this button display the maximum temperature and humidity of both indoors and
outdoors.
Press again to display the minimum temperature and humidity of both indoors and
outdoors.
Part III
Use the Transmitter:
For each weather station there is a transmitter. Set the channel after inserting the battery at
the rear of the transmitter. There are 3 settings: channel 1, 2 and 3.
The maximum distance between the station and the transmitter is 20 m in open areas.
Greater distance or buildings in-between station and transmitter will affect signal
transmission and reception.
Transmitter shall be kept away from rain or water.
Part IV
Points to note:
Tolerance:
• The tolerance for temperature variation is +/– 2 °C.
• The tolerance for humidity variation is +/– 5%.
Remarks:
1. 3x AAA batteries or DC 4.5 V adapter are needed to operate the weather station.
2. 2x AAA batteries are needed to operate the transmitter.
3. The transmitter distance is 30 m.
4. Transmits one time every second. The light will flash at the same time.
5. Select the channel and change the temperature unit inside the battery compartment.
6. When the RCC signal flashes, the handset function is turned off. Press –/RCC button once
to stop the RCC signal flashing; it will recover the handset function.
7. The system's channel is CHANNEL1.
4
ENGLISH
Publicidad
