Publicidad
Idiomas disponibles
Idiomas disponibles
Component
1. Aurora fans x 3
2. User manual x 1
3. Controller、RF remote control x 1
4. Screws x 12
5. Power wire
6. LED light strip 30cm x 2
Installation
1. Please make sure the power is off.
2. Install the fans in your PC case, and screw it in the designated areas.
3. Use power wire to connect the controller and the power.
3
4
5
6
4.
Use 4-4 pin connecting wire to connect the controller and the motherboard.
5.
Use USB-4 pin connecting wire to connect the controller and the motherboard.
6.
Use 6-6 pin long connecting wire to connect the controller and the IN
part of the first fan.
Motherboard
6
IN
7. 6-6 pin short connecting wire (connect fan to fan) x 2
8. 6-6 pin long connecting wire (connect fan to fan) x 1
9. 6-3 pin long connecting wire (connect fan to LED) x 1
10. 3-3 pin long connecting wire (connect LED to LED) x 1
11. 4-4 pin connecting wire
12. USB-4 pin connecting wire
7. Use 6-6 pin short connecting wire to connect the OUT part of the
first fan and the IN part of the second fan.
8. Use 6-6 pin short connecting wire to connect the OUT part of the
second fan and the IN part of the third fan.
9. Use 6-3 pin connecting wire to connect the OUT part of the third
fan and the LED strip.
7
OUT
IN
9
6-3 pin
10. LED strips can be connected to each other directly or be connected
through 3-3 pin connecting wire
11. RGB lighting effect can be controlled through the RF remote
control or our exclusive software.
8
OUT
IN
OUT
9
10
3-3 pin
.
P2
P3
Publicidad
