Beper 50.971 Manual De Instrucciones página 14

Steam station Use instructions
Front & Rear support
You can put the iron on the front & rear support during operation and you can also secure the iron
into front & rear support for storage after finishing ironing.
Power button
Plug in the appliance and press down the Power button, the power indicator will be illuminated, also
the low steam level regarded as defaulted one and its indicator will flash. Press down the Power
button for a while, both the power indicator and low steam level indicator will be extinguished, and
the appliance will be disconnected from the power supply.
Steam level control button
The steam level can be selected low, medium or high with the steam level control button. Any one to
be selected, its indicator will flash, after a few minutes, the indicator will be changed to illuminating.
At this time, the appliance can produce steam and you can use the steam for ironing.
Temperature dial
Turn the dial to set ironing temperature to meet the garment changed.
Temperature indicator
When the iron is heating up, the temperature indicator will be illuminated. Once the iron has reached
the selected temperature, it will extinguish. The temperature indicator will be cycled on and off as the
iron maintains the selected temperature during ironing.
Steam trigger
After pressing down the Power button and choosing the desired steam level, it indicates the ste-
am can be used for ironing until the corresponding steam level indicator is changed flashing to
illuminating. At this time, press the steam trigger with a little force, the steam will be sprayed from
the soleplate continuously. When loosen the steam trigger, the appliance can only be used for dry
ironing without steam.
Lack of water indicator and reset button:
If less water in the tank, the indicator will be illuminated, following with two beeps can be heard, the
steam generator stops working. It prompts you need to add water into the tank.
If less water in the tank, the lack of water indicator will be illuminated, at that time, you need to refill
the water tank. After refill the water tank with water, press the reset button once to make the lack of
water indicator be extinguished and then you can release steam for ironing.
Descaling indicator & De-calc box
If the descaling indicator illuminates, it indicates the mineral deposits in the de-calc box has been
collected to a degree and you should replace the de-calc box in time.
14