Sunbeam HOSPITALITY 4211 Manual De Instrucciones página 3

T F W
O Ill ThE
WARNING: To prevent the risk of burns, be careful when filling a hot iron with water. Hot metal parts,
hot water and steam can cause injuries.
1. S et the Steam Lever to O/Off (Dry) and the Fabric Select Dial to OFF. Make sure the iron is unplugged.
2. Lift the Water Fill Hole Cover.
3. F ill water cup with water. Pour water into iron water reservoir. Do not fill water reservoir beyond
maximum fill level.
D I
Ry RONING
1. Make sure the Steam Lever is turned to the
2. Plug the cord into a 220-240V outlet.
3. T urn the large Fabric Select Dial to the fabric setting you desire (Silk or Synthetics). Allow the iron to
heat for 2 minutes. While the iron is heating, make sure it is sitting on its heel rest on a stable, protected
surface.
N : While the Steam Lever is turned to the
OTE
STEAM or SPRAY MIST feature. Please make sure the water reservoir is 1/4 full of water.
T : Refer to the Ironing Guide (on Page 6) for the recommended setting for your fabric.
IP
S I
TEAM RONING
1. Follow the instructions for "Filling the Water Reservoir".
2. Plug the cord into a 220-240V outlet.
3. T urn the large Fabric Select Dial to the fabric setting you desire (Synthetic, Silk, Linen, Cotton or
Wool). Allow the iron to heat for 2 minutes. While the iron is heating, make sure it is sitting on its
heel rest on a stable, protected surface.
4. A llow the iron to heat for 2 minutes, and then turn the Steam lever to the appropriate setting.
T : Refer to the Ironing Guide (on Page 6) for the recommended setting for your fabric.
IP
I : When not ironing, always set the Steam Lever to
MPORTANT
S M F
PRAy IST EATURE
The SPRAY MIST feature is a powerful water spray mist that dampens the fabric to aid in removing
wrinkles from heavy fabrics and for setting creases.
To use the SPRAY MIST Feature:
Press the SPRAY MIST button firmly.
S S
hOT OF TEAM
(select models only – 3965-099; IR4500; 4211-099-500; 4211-099-600; 4215-098; 4273-099-500; 4273-099-600)
The SHOT OF STEAM feature provides an extra burst of steam for deep penetration of stubborn
wrinkles. You can use this feature while Dry or Steam ironing, but the water reservoir must be at least
1/4 full of water.
To use the SHOT OF STEAM Feature:
Place the iron on top of the wrinkle and press the SHOT OF STEAM button each time you would like
an extra burst of steam. The SHOT OF STEAM feature may be used continuously with just a short
pause between shots.
R
ATER ESERvOIR
U
SING ThE
F
EATURE
O
/Off (Dry) setting.
O
/Off (Dry) setting, you may still use the SHOT OF
O
/Off (Dry) and the Fabric Select Dial to OFF.
I ' S
RON S PEcIAl
3
F
EATURES