Wall Mounting - ULTIMATE SPEED UPA 500 A1 Instrucciones De Uso

Wall mounting

DANGER
► When drilling the holes ensure that any electric cables or
other installations in the wall, such as water pipes, are not
damaged.
TAKE NOTE
GB
► The supplied plugs are only suitable for a mounting on con-
MT
crete or stone. Before starting the installation, please check
your installation location carefully for its suitability for the
plugs. If in doubt, call a professional.
♦ Attach the Parking Lamp
the windshield of your vehicle. For this, mark two boreholes with
a vertical spacing of 130 mm.
♦ Attach the ultrasonic sensor on the garage wall at the level of
the bumper of your vehicle. For this, mark two boreholes with a
vertical spacing of 45 mm.
♦ Now bore, using an electric or hand drill fi tted with a 6 mm
drill, the four holes to a minimum depth of 30 mm.
♦ Insert the plugs into the holes and screw the screws in. Leave
the screw heads protruding a little.
♦ Now hang the Parking Lamp
on the screws.
NOTICE
► Alternatively, you can also use the supplied hook and loop
pads for mounting the Parking Lamp
sensor
50
7 .
Handling and operation
on the garage wall at the level of
and the ultrasonic sensor
and the ultrasonic
7
UPA 500 A1