Ultrasonic XL 800 Instrucciones De Uso página 11

Green LED flashes quickly (please charge the device or operate it with a
USB adapter).
Charging time is 8 to 12 hours.
Battery replacement
1. Remove the housing cover by loosening the 6 screws.
2. Remove the old batteries.
3. Insert four new rechargeable batteries of size Mignon (AA) 850mA
NiMh. Make sure that the polarity is correct as shown on the inside at
the bottom of the battery holder.
4. Replace the cover and retighten the screws.
Only use rechargeable batteries or operate the device using the USB
adapter. Non-rechargeable batteries may not be charged.
General information
1. Electric appliances, packaging material etc. should be kept away from
children.
2. Dispose packaging and worn out material correctly and in an
environmentally friendly way.
3. Do only pass on the device including the operation manual.
4. Subject to change of design and technical data without notice for the
sake of constant product improvement.
Safety instructions
Important: Damage caused by not adhering to the operating instructions
is not covered by guarantee. ISOTRONIC accepts no liability whatsoever
for any resulting consequent damages.
- Only operate the device at its intended voltage.
- In case of repairs, only use original spare parts, to avoid serious
damage.
- Check feed cables and conducting cables connected to the device for
breaks or insulation defects. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
- Repairs or others works, e.g. changing a fuse, etc. may only be carried
out by an appropriately trained, skilled person.
- It must be noted that operator or connecting errors lie outside the
influence of ISOTRONIC and we cannot accept any liability for
resulting damages.
- Always check whether the device is suitable for the respective place
where you intend using it.
- This appliance is not intended for use by persons (including children)