Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS / DIRECTIONS FOR USE
#1031 UNIT SHOWN
FIG. 2
SIDE VIEW
Bemis Manufacturing Co., 300 Mill Street, Sheboygan Falls, WI 53085
920-467-4621 • 800-558-7651 • Fax 800-499-8160
E-mail: HCG@BemisMfg.com • www.bemishealthcare.com
A
B
C
D
FIG. 1
Tabs
Release Tab
CLEANING INSTRUCTIONS FOR CABINET
Clean cabinet regularly to maintain appearance and function. Wipe exterior of
cabinet with damp cloth and mild soap or disinfectant. Never clean with solvents
such as acetone or alcohol. Do not attempt to clean interior of cabinet when sharps
container is installed. Clean interior of cabinet using mild soap or disinfectant.
Installation Instructions
Cabinets can be installed using holes from existing units or on any new wall
surface. Install at a recommended height of 53"-56" from top of cabinet to floor.
Note: Hardware not included. Use appropriate fasteners for your wall construction.
TO INSTALL ON NEW WALL SURFACE (FIGURE 1):
Do not drill holes without first checking for plumbing or wiring behind wall. Using
back of cabinet as a template, mark hole locations with a pencil. Drilling at least
four holes is recommended using mounting slots A, B, C or D. Drill holes and secure
cabinet to wall using appropriate fasteners.
TO INSTALL USING EXISTING HOLES:
Loosen top fasteners left from existing bracket or cabinet and remove bottom fasteners.
Slide new cabinet into position on top fasteners using keyhole slots. Replace bottom
fasteners using any mounting slots C, D or below.
TO INSTALL OPTIONAL #1041 GLOVE BOX
HOLDER TO CABINET (FIGURE 2):
Insert tabs on left and right side of glove box into matching slots on bottom
of cabinet until it snaps into position.
TO REMOVE GLOVE BOX FROM CABINET:
Holding glove box with both hands, push in release tab on either left or right
side while pulling down until glove box is removed.
Directions for use
TO INSERT SHARPS CONTAINER IN CABINET:
1. With biohazard label facing front, slide container straight into cabinet.
2. Close and lock cabinet door.
TO REMOVE FULL SHARPS CONTAINER FROM CABINET:
1. Insert final disposal tabs into slots on lid of sharps container.
Push down and snap into place.
2. Unlock and open cabinet door.
3. Place both hands underneath handles and slide container out of cabinet.
Dispose of according to hospital policy.
4. Insert new sharps container into cabinet; close and lock door.
SHARPSENTINEL
WALL CABINET SYSTEM
®
Rev. 2.0
©2017 599 6390
Publicidad
