Ethernet Configuration - OHAUS Scout 30268986 Manual De Instrucciones

1.800.561.8187
Ethernet Interface

ETHERNET CONFIGURATION

To set the Ethernet parameters per web.
1. Make sure the Ethernet Interface Kit is installed properly and network cable is
connected to a computer (PC).
2. Set the PC to obtain an IP address automatically as shown below.
3. Open the IE Browser and enter the default IP address of the Ethernet
Interface Kit "169.254.1.1" (
show below page:
4. Click the "Network Configuration" on the left side, and input the user &
password. Then click "OK" to proceed.
5. Input the Ethernet parameters in the following page, click "Save Config" to
save the changes.
Note:

To use DHCP, enable the DHCP:
www.
), the browser will
Password: ohaus
information@itm.com
.com
EN-7
User: ohaus