Fault Finding; Product Liability - KREBS Tex-2 Instrucciones De Manejo

Fault finding

Fault
Spraying jet is irregular
Irregular operating sound
No suction
Unit does not run with normal a) Piston seized in cylinder. You have sprayed an
operating sound but only
hums quietly.
Ring marks remain in material Wrong jet setting, incorrect operation, drying not carried
Threads are displaced
VARIA Nozzle leaks
Nozzle clogged

Product liability

No liability is accepted for damage caused directly or indirectly by the use and spraying
of products.
6 Months Guarantee
The guarantee covers the remedying of all faults, without cost to the customer, arising from
faulty manufacture of materials. This guarantee excludes damage caused by ingress of dirt,
insufficient and/or incorrect maintenance.
THEO KREBS LTD
Cause and remedy
Nozzle clogged
(Clean nozzle or send to manufacturer)
a) Incorrect setting of setting screw
(See Preparation)
b) Insufficient fluid in container
a) Suction tube loose
b) Setting screw turned too far in clockwise direction.
(See Preparation)
unsuitable medium. Should cylinder piston be too
badly damaged, the complete pump assembly must
be replaced.
b) Nozzle head is completely clogged.
(Clean or send to manufacturer)
c) Pump weared out (replace)
out properly.
Jet is too concentrated, distance between fabric is not
enough, angle of spraying is incorrect. (See Tips)
Tighten nozzle head and threaded holder against each
other.
Clean nozzle head and swirl head as instructed.
13